![]() However, most good GUIs will help out by attaching descriptions for you, so you know what you are looking at. This was done to free up precious flash memory to add the new features available in v1.1. In prior versions of Grbl, each setting had a description next to it in () parentheses, but Grbl v1.1+ no longer includes them unfortunately. The x of $x=val indicates a particular setting, while val is the setting value. All of these settings are persistent and kept in EEPROM, so if you power down, these will be loaded back up the next time you power up your Arduino. ![]() ![]() Grbl should respond with a list of the current system settings, as shown in the example below. To view the settings, type $$ and press enter after connecting to Grbl. ![]() These either immediately change Grbl’s running behavior or immediately print a report of the important realtime data like current position (aka DRO). The last four non-‘$’ commands are realtime control commands that can be sent at anytime, no matter what Grbl is doing. The ‘$’-commands are Grbl system commands used to tweak the settings, view or change Grbl’s states and running modes, and start a homing cycle. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |